Optically-powered Low Power Low Noise Amplifiers for MRI

Reza Aghabagheri, Jakob Gerlach, Zining Liu, Morteza Teymoori, Caglar Ataman, Michael Bock, Ali Caglar Oezen

Purpose: Fully optical receive coils can potentially allow dense receiver arrays with a large channel count, reduced channel crosstalk, and less cable clutter. The power requirements of conventional low-noise amplifiers (LNAs) are prohibitive for simultaneously driving many coils through optical means, as opto-electric power conversion efficiencies can only reach about 50%. The goal is to develop low-power LNAs (LPLNA) with substantially lower power consumption without compromising noise figure (NF) and gain. Methods: A LPLNA was designed as a two-stage cascaded amplifier using an MR-compatible E-pHEMT (Enhancement-mode Pseudomorphic High Electron Mobility Transistor) transistor. The design was implemented on a single-sided printed circuit board (PCB), and its performance was compared with a commercial LNA. A four-channel shielded loop resonator array was constructed, and the signal-to-noise ratio (SNR), noise covariance, and preamplifier decoupling performance were evaluated. Results: The LPLNA had a five-fold lower electrical power consumption (40 mW) than the commercial LNA and provided comparable SNR in phantom measurements. In vivo experiments further confirmed that the LPLNA operates reliably under realistic MRI conditions. Additionally, four-channel receiver array measurements demonstrated comparable SNR within 2% of the commercial LNA and lower inter-channel noise correlation with 0.26 vs 0.3 on average. Conclusion: This study demonstrates the feasibility of LPLNAs for optically-powered RF receiver coil arrays. The LPLNA could also be applied in power-constrained or remote MRI environments.